SILENT KNIGHT 9800 Spécifications télécharger pdf (Page 22)

Installation

151018 3-7

5. Carefully slide the line card into its guides (both top and bottom) until it fits into its

connector at the back of the receiver. Gently push the line card as far into the connector as

you can. The line card is now in place.

6. Connect telephone line. (See Section 3.7 for telephone line installation.)

Note: Use the tie wrap (P/N 120101 provided with each line card) on the tie wrap holder to add strain relief to

the telephone lines. See Figure 3-2.

7. Power up the 9800.

8. Close the 9800's front panel and tighten the front plate retaining screws to hold the front

plate in place. If you are simply replacing a line card with another card of the same type

and are using the same format settings, your installation is now complete. If not continue

to the next step.

9. Enter programming mode to select the appropriate handshake configuration. (Go to

Section 5.5 for programming procedure.)

3.6 Removing Line Cards

If you need to remove a 9810 or 9815 line card:

1. Open the 9800's front panel by unscrewing the four front plate retaining screws located on

the front of the panel. (See Figure 3-1 for front plate retaining screw locations.)

2. Turn off the 9800’s power by disconnecting the AC power cable and backup battery.

With the front panel removed, you will see that there are 12 slots for line cards.

3. Locate the line card that you wish to remove.

4. Unplug the telephone line. (See Figure 3-5 and Figure 3-6.)

5. From the front side of the receiver pull the line card straight back. This will pull the card

free from the connector.

6. When the line card is free, slide it carefully out of the receiver.

Note: If replacing a line card with a new one see Section 3.5 to install the new line card.

7. Power up the 9800.

8. Close the 9800's front panel and tighten the front plate retaining screws to hold the front

plate in place.

9. Enter programming mode to clear the line card from the system. (See Section 5.5 for

programming procedure.)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 167 168

Pas de commentaire

SILENT KNIGHT 9800 Spécifications Page 22